Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Dmz (Not-Monitored)

Hi all,could you please explain me what is meant of Dmz & Dmz 1 Normal (Not-Monitored)?

Thanks

Asa5540# sh failover

Failover On

Failover unit Secondary

Failover LAN Interface: failover GigabitEthernet0/3.1 (up)

Unit Poll frequency 1 seconds, holdtime 15 seconds

Interface Poll frequency 5 seconds, holdtime 25 seconds

Interface Policy 1

Monitored Interfaces 3 of 250 maximum

Version: Ours 7.2(2), Mate 7.2(2)

Last Failover at: 08:33:52 CEST Mar 16 2007

This host: Secondary - Active

Active time: 3849 (sec)

slot 0: ASA5540 hw/sw rev (1.1/7.2(2)) status (Up Sys)

Interface outside (x.x.x.x): Normal

Interface inside (172.16.0.101): Normal

Interface dmz (10.0.10.254): Normal (Not-Monitored)

Interface dmz1 (10.0.11.254): Normal (Not-Monitored)

Interface backup (x.x.x.x): Normal

slot 1: ASA-SSM-20 hw/sw rev (1.0/6.0(1)E1) status (Up/Up)

IPS, 6.0(1)E1, Up

Other host: Primary - Standby Ready

Active time: 13319 (sec)

slot 0: ASA5540 hw/sw rev (1.1/7.2(2)) status (Up Sys)

Interface outside (x.x.x.x): Normal

Interface inside (172.16.0.102): Normal

Interface dmz (10.0.10.253): Normal (Not-Monitored)

Interface dmz1 (10.0.11.253): Normal (Not-Monitored)

Interface backup (x.x.x.x): Normal

slot 1: ASA-SSM-20 hw/sw rev (1.0/6.0(1)E1) status (Up/Up)

IPS, 6.0(1)E1, Up

Stateful Failover Logical Update Statistics

Link : stateful GigabitEthernet0/3.2 (up)

Stateful Obj xmit xerr rcv rerr

General 10559 0 40860 0

sys cmd 2268 0 2261 0

up time 0 0 0 0

RPC services 0 0 0 0

TCP conn 491 0 1758 0

UDP conn 243 0 276 0

ARP tbl 7557 0 36565 0

Xlate_Timeout 0 0 0 0

VPN IKE upd 0 0 0 0

VPN IPSEC upd 0 0 0 0

VPN CTCP upd 0 0 0 0

VPN SDI upd 0 0 0 0

VPN DHCP upd 0 0 0 0

Logical Update Queue Information

Cur Max Total

Recv Q: 0 5 71171

Xmit Q: 0 2 14408

Asa5540#

1 REPLY
Cisco Employee

Re: Dmz (Not-Monitored)

Hello,

It means that DMZ is in normal operational status but you are not monitoring that interface for fail over conditions. Other interfaces are monitored for fail over to take effect is something goes wrong.

By default it is set to Monitor status.

Command to turn on monitoring would be

monitor-interface

Rate this post, if it helps

Cheers

Gilbert

255
Views
0
Helpful
1
Replies
CreatePlease to create content