Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Doing NAT for VPN clients going over L2L tunnel

Hi.I have the following situation in my network.We have a need for users who connect to our site with VPN clients to connect to another site via a L2L tunnel. The problem is that I need to NAT the addresses from the VPN client pool to another range before going over the L2L tunnel because on the other side we have overlapping networks.

I have been trying to do NAT along the following lines with little success:

ACL for NAT of VPN pool:

access-list TEST extended permit ip 192.168.253.0 255.255.255.0 192.168.0.0 255.255.255.0

access-list TEST extended permit ip 192.168.253.0 255.255.255.0 192.168.5.0 255.255.255.0

NAT:

global (outside) 15 172.20.105.1-172.20.105.254

nat (inside) 15 access-list TEST

CRYPTO ACL:

access-list RO extended permit ip LAN 255.255.0.0 192.168.0.0 255.255.255.0

access-list RO extended permit ip LAN 255.255.0.0 192.168.5.0 255.255.255.0

access-list RO extended permit ip 172.20.105.0 255.255.255.0 192.168.0.0 255.255.255.0

access-list RO extended permit ip 172.20.105.0 255.255.255.0 192.168.5.0 255.255.255.0

same-security-traffic permit intra-interface

Am I missing something here? Can something like this be done at all?

Thanks in advance for any help.

We are using ASA 5510 with software version 8.0(3)6.

1 ACCEPTED SOLUTION

Accepted Solutions
Green

Re: Doing NAT for VPN clients going over L2L tunnel

You need to nat on the outside, not the inside.

nat (outside) 15 access-list TEST

2 REPLIES
Green

Re: Doing NAT for VPN clients going over L2L tunnel

You need to nat on the outside, not the inside.

nat (outside) 15 access-list TEST

New Member

Re: Doing NAT for VPN clients going over L2L tunnel

Thanks.I did it already.I realized with the help of a friend I was using the wrong logic for the NAT and changed it.

Now I can get ping across the L2L tunnel from the VPN client without fail.

Thanks for the reply though.

133
Views
0
Helpful
2
Replies