Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Dual ISP links and SLA on ASA 5505-50

I have two Internet links:

  • ISP1: only Site 2 Site VPNs
  • ISP2: only HTTP/HTTPS traffic and incoming remote access VPNs

With the security plus license I could correctly configure them both as active at the same time on the same ASA device. Also, I've successfully accomplished the following traffic separation:

  • Site to Site VPNs goes out through ISP1
  • HTTP/HTTPS traffic goes out through ISP2

The customer request is that, when ISP1 fails the S2S traffic is relayed through ISP2 -> This is working fine, I've already tested!

But when ISP1's service is restored and that link is working fine, I want that the S2S VPN traffic gets relayed through it again automatically, which didn't happen. My question is: using SLA will the S2S traffic be relayed through ISP1 again automatically when it's services are restored? If not, which technology should I use to accomplish this?

PS: This is all configured on only 1 ASA 5505 whose license was upgraded.

Thanks in advance for any help!

Everyone's tags (5)
2 REPLIES
New Member

Dual ISP links and SLA on ASA 5505-50

So, no ideas about this? Anything?

Dual ISP links and SLA on ASA 5505-50

Hello Pedro,

Can you post your SLA configuration ,tracking configuration with the routing configuration as well, you can change the IP addresses for security purposes.

Regards,

Julio

Looking for some Networking Assistance? Contact me directly at jcarvaja@laguiadelnetworking.com I will fix your problem ASAP. Cheers, Julio Carvajal Segura http://laguiadelnetworking.com
546
Views
0
Helpful
2
Replies
CreatePlease login to create content