Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Dynamic map seq number change in ASA 5510

Hi all

I am migrating from 3005 to ASA 5510. (no previous experience vit ASA/PIX before) Everything works ok exept one irritating issue.

I added in (ASDM)a remote access VPN for use with client and Easyvpn, works fine. When i after that add a site to site VPN the seq nbr on the dynamic map will change and all connected remote access VPN's will disconnect. I have tried to set the seq nbr on the dynamic map to 65535 (with telnet session) but when i add the next L2l (via ASDM wizard) it is changed back to "100" or whatever is the next in range. Anyone out there who knows if there is a way to prevent this ?

brgds

Mats

5 REPLIES
Silver

Re: Dynamic map seq number change in ASA 5510

What is the software version which your are using in the ASA?

New Member

Re: Dynamic map seq number change in ASA 5510

Hello

It is 7.2.1 and ASDM 5.2.1

thx

New Member

Re: Dynamic map seq number change in ASA 5510

Hi Mats,

We have the same versions and suffer the same issues. Did you ever find a solution, to the problem.

thanks

phil

New Member

Re: Dynamic map seq number change in ASA 5510

Hi

noop I didn't. I left the VPN clients on the 3005 concentrator and use the ASA for Lan to Lan only.

rgds

Mats

New Member

Re: Dynamic map seq number change in ASA 5510

Thanks for the prompt reply Mats,

Will just have to suffer knocking off my VPN remote access clients each time the ASDM Wizard wants to write config for a new lan-to-lan VPN.

rgds

phil.

130
Views
0
Helpful
5
Replies
CreatePlease login to create content