Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

dynamic virtual tunnel interface on 2821

Hi all.

I have a 2821 with software 12.4(9)T1 advanced ip services.

I tried to configure a dynamic virtual tunnel interface to terminate VPN client ipsec sessions.

Reading documentation, it says to configure

interface virtual-template <number>

tunnel mode <mode>

But router does not accept "tunnel" command on interface configuration.

This feature seems supported by this software release.

Any hint?

Thank you in advance.

denis

  • VPN
3 REPLIES

Re: dynamic virtual tunnel interface on 2821

Hi

You can refer the below link in configuring the same..

http://www.cisco.com/en/US/tech/tk583/tk372/tech_configuration_examples_list.html#anchor16

regds

New Member

Re: dynamic virtual tunnel interface on 2821

when declaring the virtual template you need specify the mode as follows:

int virtual-template <1-200> type tunnel

then you may issue the subsequent tunnel subcommands

hope this helps!

New Member

Re: dynamic virtual tunnel interface on 2821

Hi, I forgot I had this open!

I solved the problem upgrading the image.

Documentation, at least what I found, states this feature is supported on 12.4(9)T1 but I really can't agree.

You'll need a 12.4(11)T1 or higher.

Thank you all.

123
Views
0
Helpful
3
Replies
This widget could not be displayed.