I have a situation in which, when I setup my static VTI's I have traffic passing successfully across the tunnel. For the destination i wish to use I put a route on both static configuration simmilar to the following - ip route 172.30.0.0 255.255.255.0 tunnel 0. This works without any issues.
Now I've redesigned the scenario using DVTIs my tunnel is up and the traffic is coming from the remote location to the branch, however, the HUB is not returning the traffic.
Please see below. All help is appreciated.
HUB Site ---
! Show Crypto isa sa
IPv4 Crypto ISAKMP SA
dst src state conn-id slot status
220.127.116.11 18.104.22.168 QM_IDLE 1002 0 ACTIVE myISAKMPProfile
22.214.171.124 126.96.36.199 QM_IDLE 1003 0 ACTIVE myISAKMPProfile
! show cryp ipsec sa
Crypto map tag: Virtual-Access2-head-0, local addr 188.8.131.52
protected vrf: (none)
local ident (addr/mask/prot/port): (0.0.0.0/0.0.0.0/0/0)
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...