Is there a way to reduce the peer timeout setting on the client so it will fail over to a second Easy VPN server more quickly? Right now it seems to be taking about 60 seconds and I'd like to reduce that if possible. There used to be a checkbox in the VPN client to change that value but I can't find a corresponding hardware client configuration setting for that.
configure mode commands/options: disconnect-notify Enable disconnect notification to peers identity Set identity type (address, hostname or key-id) nat-traversal Enable and configure nat-traversal reload-wait Wait for voluntary termination of existing connections before reboot
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...