I am trying to deploy a Cisco 1841 router as easy vpn client whearas a Cisco 3845 router has already been configured as vpn server. The issue is that when after doing the configuration on vpn client (as in the document in url) I try to use the command
Thanks for replying. I did as you said. It accepts the command " connect auto " but when i check the status through " sh crypto isakmp sa " command there is nothing. I think it does not initialize the vpn connection. However i have tested the configuration of vpn server by connecting throug vpn client software which works. thans.
the tunnel will be built only when there is an interresting traffic, so may be you need to specify your interresting traffic, with classical config is created by the access-list that you specify under your crypto map.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...