cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
219
Views
0
Helpful
1
Replies

EasyVpn

sprocket10
Level 2
Level 2

 

I have successfully created a tunnel between our cisco router and 5510 ASA using easyvpn.

I currently have it running in Network-Plus mode where the router receives an ip address from the ASA when it connects from its pool. However this will change on each connection.

I changed it to Network-Extension in the hope the router will connect and be manageable via its own ip but it fails to connect.

What do I need to set on the ASA to allow the connection to use its own ip?

 

1 Accepted Solution

Accepted Solutions

Poonam Garg
Level 3
Level 3

you have to enable NEM on ASA for it to work using the cmd:

# nem enable

View solution in original post

1 Reply 1

Poonam Garg
Level 3
Level 3

you have to enable NEM on ASA for it to work using the cmd:

# nem enable

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: