Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

EIGRP with DMVPN

Why there is a need to increase the tunnel interface bandwidth when running EIGRP with DMVPN?

Thanks,

1 ACCEPTED SOLUTION

Accepted Solutions

Re: EIGRP with DMVPN

The default value is 9. The recommend bandwidth value is 1000 or greater. Setting the bandwidth value to at least 1000 is critical if EIGRP is used over the tunnel interface. Higher bandwidth values may be necessary depending on the number of spokes supported by a hub. The bandwidth setting for the spoke does not need to equal the bandwidth setting for the DMVPN hub. It is usually easier if all of the spokes use the same or similar value.

Francisco

2 REPLIES

Re: EIGRP with DMVPN

The default value is 9. The recommend bandwidth value is 1000 or greater. Setting the bandwidth value to at least 1000 is critical if EIGRP is used over the tunnel interface. Higher bandwidth values may be necessary depending on the number of spokes supported by a hub. The bandwidth setting for the spoke does not need to equal the bandwidth setting for the DMVPN hub. It is usually easier if all of the spokes use the same or similar value.

Francisco

Re: EIGRP with DMVPN

by the way

bandiwdth with eigrp with dmvpn used for redundancy

while if u use ospf u can use link cost

hope this helps

184
Views
1
Helpful
2
Replies
CreatePlease to create content