Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Emulate Internet with PT-Cloud in Packet Tracer

hi,

I want to emulate internet with PT-Cloud in Packet Tracer. After this i will try to config IPSec VPN. I have config IPs but i don't have connectivity between 2 routers.

what should i do ?

Thanks,

John

6 REPLIES

Re: Emulate Internet with PT-Cloud in Packet Tracer

Hi,

If you want to emulate the Internet and since you're using a DSL modem, you need to configure the DSL settings to properly communicate with the cloud.

If you're good with that go ahead... otherwise you can just do the following:

Router 1 ----- Router 2 ---- Router 3 ---- Router 4

Now, you can have an IPsec tunnel between Router 1 and Router 4 exactly with the same configuration as if it was going over the Internet.

Hope it helps.

Federico.

New Member

Re: Emulate Internet with PT-Cloud in Packet Tracer

Thanks, i have found the way with PT-Cloud finaly.

New Member

Re: Emulate Internet with PT-Cloud in Packet Tracer

john,

Could you post your router configuration please?

I'm trying to do similar setup using wireless router using PPPoE

WirelessRouter -- DSLModem -- Cloud -- ISProuter

I want to ping from WirelessRouter to ISPRouter

Any help would be greatly appreciated.

Thanks.

New Member

Re: Emulate Internet with PT-Cloud in Packet Tracer

Hi Philip,

This is how PT-Cloud works:

1- Connect PT-Cloud just like in the picture

2- PT-Cloud/Config/DSL, add the way (Route) to go througt the cloud

3- Τhe most important part is to put a "ISP router" on the opposite side of the moden, where PT-cloud separates them.

4- Finally, set the interfaces of the "ISP router" on the same network with the interfaces wich is directly connected or communicates througt PT-Cloud.

I hope that this will help.

Regards,

John

New Member

Emulate Internet with PT-Cloud in Packet Tracer

Thank You for this information.

Best Regards,

Didier

New Member

Re: Emulate Internet with PT-Cloud in Packet Tracer

Hi everybody I have exactly the same problem, I read your comment but I can not really understand why I would like to have help please
55784
Views
9
Helpful
6
Replies
CreatePlease to create content