Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

EzVPN and Double PAT Question

I have a site with a DSL modem providing PAT then with our router providing PAT and EzVPN in Network Extension Mode. My question is how does EasyVPN react to this setup? Which addresses does it see as end-points, and how does it affect the possibility of adding additional sites with the same setup?

I ask because it is a lot easier for me to configure PAT on my router and let it get PAT'd by the modem then trying to figure out how to put each different carrier's DSL modem into a pass-through mode.

Any thoughts or comments on this practice?

CreatePlease to create content