It seems that in order to enable dhcprelay on the ASA you have to point the relay out the outside interface. Can anyone say for sure if this traffic is still getting encrypted when using the ASA as an EZVPN NEM client?
I haven't had a chance to test it yet...does that configuration work?
I don't think this will work, typically ezvpn creates an SA from the outside of the client to the outside of the server, but in this case I am not sure it and since this is not affected by split tunnel or any config I doubt it will work. Reason you need to make sure that an SA is created from outside of the ASA to the DHCP server, not the EZVPN server. Your most feasible solution would be a normal dynamic to static and yet on this one you will find problems when the ip address changes.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...