Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Fialover

I have PIX-535-UR-BUN and PIX-535-FO-BUN, and it is works good 1 year, but now I have a problem:

The first firewall (PIX-535-UR-BUN) reload itsalf, and the second PIX-535-FO-BUN will be a primary. In my syslog I see next:

Apr 13 09:41:56 pix535-agg-security Apr 13 2007 09:41:55 pix535-agg : %PIX-1-103001: (Secondary) No response from other firewall (reason code = 3).

Apr 13 09:41:56 pix535-agg-security Apr 13 2007 09:41:55 pix535-agg : %PIX-1-104001: (Secondary) Switching to ACTIVE - no response from mate.

Apr 13 09:42:32 pix535-agg-security Apr 13 2007 09:42:31 pix535-agg : %PIX-1-102001: (Secondary) Power failure/System reload other side.

Apr 13 09:42:47 pix535-agg-security Apr 13 2007 09:42:46 pix535-agg : %PIX-1-101001: (Secondary) Failover cable OK.

Apr 13 09:43:02 pix535-agg-security Apr 13 2007 09:43:01 pix535-agg : %PIX-1-105003: (Secondary) Monitoring on interface Security waiting

Apr 13 09:43:02 pix535-agg-security Apr 13 2007 09:43:01 pix535-agg : %PIX-1-105003: (Secondary) Monitoring on interface Failover waiting

and so....

and in CLI PIX-535-UR-BUN I saw error :

Attempted to free nonchunk memory, chunk 7953554, data 7972ae4

What does it mean? And what I must do......

With Kind Regards,

Andrey!

4 REPLIES
Silver

Re: Fialover

PIX-1-103001: (Primary) No response from other firewall (reason code = code).

Explanation This is a failover message. This message is logged if the primary unit is unable to communicate with the secondary unit over the failover cable. "(Primary)" can also be listed as "(Secondary)" for the Secondary unit.

Action Verify that the secondary unit has the exact same hardware, software version level, and configuration as the primary unit.

Refer this link:

http://www.cisco.com/en/US/products/sw/secursw/ps2120/products_system_message_guide_chapter09186a0080485923.html#wp1019988

New Member

Re: Fialover

I mean that my UR PIX is reload itself, and I do not understand why....

Help!!!!

Bronze

Re: Fialover

what version are you running. It seems that you have hit a bug. I have seen this issue in 6.3.3 and i had downgraded to 6.2. I dont know if it is fixed in 6.3.5 or not. You need to check with the TAC on that.

--HTH--

regards

Zubair

New Member

Re: Fialover

I have Cisco PIX Firewall Version 6.3(5) in my UR and I do not have a loggin and pass to the TAC , I can only call in support... You think they help me......

140
Views
0
Helpful
4
Replies