I was wondering if an expert on FlexVPN would be able to comment on this..
I am looking to use FlexVPN hub and spoke deployment using the FLEXoMPLS feature... So I will have hub routers connected to remote routers via IPSec/GRE tunnels. This enables VRFs at hub and spokes to be joined via MPLS point-to-point link.
Can someone please confirm if it would be possible to NAT at the remote site with the VRF interface being on the inside and the IPSec/GRE tunnel in the global VRF on the outside??
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...