08-28-2010 07:28 PM
Looking for an ASA 8.0 sample configuration for enabling traffic flow between a Cisco VPN remote access client and destination host connected via LAN/Site-to-Site tunnel. Both remote access client and site-to-site tunnel terminate on the same ASA device.
Thanks in advance.
-Rey
Solved! Go to Solution.
08-28-2010 10:30 PM
Hello Rey,
Here is a config example for what you are looking for.
Hope this helps.
P.S: This uses TACACS+ for authentication which you can substitute with your method of authentication.
Regards,
Prapanch
08-28-2010 08:10 PM
Hello,
As long as both VPN sessions are working, you can try the configuration below:
access-list nonat permit ip
access-list nonat permit ip
access-list nonat permit ip
access-list nonat permit ip
nat (inside) 0 access-list nonat
Hope this helps.
Regards,
NT
Message was edited by: Nagaraja Thanthry
08-31-2010 09:53 AM
Thanks!
08-28-2010 10:30 PM
Hello Rey,
Here is a config example for what you are looking for.
Hope this helps.
P.S: This uses TACACS+ for authentication which you can substitute with your method of authentication.
Regards,
Prapanch
08-31-2010 09:54 AM
Thanks! This is my answer!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: