Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Flow between VPN Client and Site-to-Site VPN

Looking for an ASA 8.0 sample configuration for enabling traffic flow between a Cisco VPN remote access client and destination host connected via LAN/Site-to-Site tunnel.  Both remote access client and site-to-site tunnel terminate on the same ASA device.

Thanks in advance.

-Rey

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Flow between VPN Client and Site-to-Site VPN

Hello Rey,

Here is a config example for what you are looking for.

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a008046f307.shtml

Hope this helps.

P.S: This uses TACACS+ for authentication which you can substitute with your method of authentication.

Regards,

Prapanch

4 REPLIES
Cisco Employee

Re: Flow between VPN Client and Site-to-Site VPN

Hello,

As long as both VPN sessions are working, you can try the configuration below:

access-list nonat permit ip

access-list nonat permit ip

access-list nonat permit ip

access-list nonat permit ip

nat (inside) 0 access-list nonat

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00804675ac.shtml

Hope this helps.

Regards,

NT

Message was edited by: Nagaraja Thanthry

New Member

Re: Flow between VPN Client and Site-to-Site VPN

Thanks!

Cisco Employee

Re: Flow between VPN Client and Site-to-Site VPN

Hello Rey,

Here is a config example for what you are looking for.

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a008046f307.shtml

Hope this helps.

P.S: This uses TACACS+ for authentication which you can substitute with your method of authentication.

Regards,

Prapanch

New Member

Re: Flow between VPN Client and Site-to-Site VPN

Thanks!  This is my answer!

240
Views
0
Helpful
4
Replies
CreatePlease to create content