The FWSM 3.2 version is required to replace 2.3 version.
The version are using different commands and I wish to know how to do the translation between the current config-files (about 8 contexts plus 1 system context)and the target config-files supported by the new version.
Unless, there is an automotic update done during the installation?
This link provides upgrading process details and requirements for both single and multiple context. Even though this pertains upgrading from 2.x to 3.1 based on the link above,the details presented in this applies to upgrading to 3.2 as well.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...