recently i am tryinng to configure get VPn on my routers, where all the sites are connected over MPLS and cisco 3845 router on the HO as Key server and for testing one GM 2811 on the remote site. After configuring it my tunnel is estabslished but afetr 24 hours once the SA expires i have to manully clear it and then tunnle comes up. i have upgraded the IOS also but no luck. for testing purpose i just decresed the timers to 300 sec to verify the results with some other parameters. but still after 5 minutes tunnel go down. i am attaching the logs and configurations if someone suggest anything i would appreciate.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...