Hello, I have a 4 locations and currently running layer 3 links across the sites. i have my pix firewall connected to a 6509 switch and both of these boxes are located in the main office. The PIX (525) has three interfaces, 1 int-Public, 1-int inside, 1-int-guest. I built a layer 2 vlan on the 6509 and this cross-connect directly to the PIX guest Int. Any users that are on this Guest Vlan gets to the internet fine and no visibility to my internal network. I would like to extend this to my other sites. Is anybody out there currently have this setup? if so, how should i configure my other sites to point directly to this guest vlan through the main office. please advise
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...