Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

How can I assign IP pools of different subnet to anyconnect clients?

Hi,

I am trying to set up my ASA 5510 ver 8.3 (ASDM 6.3). My inside network is 192.168.1.0 mask 255.255.255.0. My Anyconnect clients can access the inside network if I use an address pool of the same subnet. When I use an address pool of different subnet such as 172.16.1.*, Anyconnect clients can connect but they can't access the inside network. Please help!

Thanks,

Simon

1 REPLY
Cisco Employee

Re: How can I assign IP pools of different subnet to anyconnect

You would need to create NAT exemption for ip pool in different subnet as follows:

object network obj-192.168.1.0

     subnet 192.168.1.0 255.255.255.0

object network obj-172.16.1.0

     subnet 172.16.1.0 255.255.255.0

nat (inside,outside) source static obj-192.168.1.0 obj-192.168.1.0 destination static obj-172.16.1.0 obj-172.16.1.0

Hope that helps.

426
Views
0
Helpful
1
Replies
CreatePlease to create content