cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
446
Views
0
Helpful
5
Replies

How do I apply an ACL to a LAN-to-LAN tunnel?

anowell
Level 1
Level 1

I have an ASA with a active IPSec LAN-to-LAN tunnel and I'm wanting to limit what ports and IPs my extranet partner is able to reach. How do I apply an ACL to a LAN-to-LAN tunnel to limit ingress and egress traffic through the tunnel?

Thanks in advance!

2 Accepted Solutions
5 Replies 5

Thanks for the link but I am trying to limit access in regards to a LAN-to-LAN tunnel and not remote access. Any more thoughts?

Thanks in advance!

It will work similarly. You need to use VPN filters. If you are using 8.0, then you can use the following doc:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00808c9a87.shtml

Thanks a lot guys, that was the info I needed! :-)

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: