Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

How do I apply an ACL to a LAN-to-LAN tunnel?

I have an ASA with a active IPSec LAN-to-LAN tunnel and I'm wanting to limit what ports and IPs my extranet partner is able to reach. How do I apply an ACL to a LAN-to-LAN tunnel to limit ingress and egress traffic through the tunnel?

Thanks in advance!

2 ACCEPTED SOLUTIONS

Accepted Solutions
Cisco Employee

Re: How do I apply an ACL to a LAN-to-LAN tunnel?

It will work similarly. You need to use VPN filters. If you are using 8.0, then you can use the following doc:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00808c9a87.shtml

Hall of Fame Super Blue

Re: How do I apply an ACL to a LAN-to-LAN tunnel?

5 REPLIES

Re: How do I apply an ACL to a LAN-to-LAN tunnel?

Community Member

Re: How do I apply an ACL to a LAN-to-LAN tunnel?

Thanks for the link but I am trying to limit access in regards to a LAN-to-LAN tunnel and not remote access. Any more thoughts?

Thanks in advance!

Cisco Employee

Re: How do I apply an ACL to a LAN-to-LAN tunnel?

It will work similarly. You need to use VPN filters. If you are using 8.0, then you can use the following doc:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00808c9a87.shtml

Hall of Fame Super Blue

Re: How do I apply an ACL to a LAN-to-LAN tunnel?

Community Member

Re: How do I apply an ACL to a LAN-to-LAN tunnel?

Thanks a lot guys, that was the info I needed! :-)

145
Views
0
Helpful
5
Replies
CreatePlease to create content