Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How do you enable/upload packet captures on ASA5520

I need to setup packet sniffs on the inside and outside interfaces of the ASA for both inside and outside interface monitoring. What is the syntax for the monitoring, and how do I save/copy the .pcap file off the asa? Also, how do you specify the random source port (gt1023)?

Here's my stab at an inside example:

packet-tracer input inside udp 10.1.0.1 xxx 207.1.1.1 sip detailed

Also, can I run an inside and outside trace simultaneously?

Thanks,

-Scott

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: How do you enable/upload packet captures on ASA5520

Scott,

After setting the capture

browse to

http://ipadd of pix/capture/pcap/sip-trace

Make sure you have http enabled on that interface you are trying to access.

Rate it, if this helps!!

gilbert

3 REPLIES
New Member

Re: How do you enable/upload packet captures on ASA5520

I think I got the trace right (correct me if I'm wrong), but need to figure out how to get it off the box:

capture sip-test trace access-list sip-trace interface inside

access-list sip-trace permit udp 10.1.1.1 gt 1023 207.1.1.1 eq 5060

Thanks,

-Scott

Cisco Employee

Re: How do you enable/upload packet captures on ASA5520

Scott,

After setting the capture

browse to

http://ipadd of pix/capture/pcap/sip-trace

Make sure you have http enabled on that interface you are trying to access.

Rate it, if this helps!!

gilbert

New Member

Re: How do you enable/upload packet captures on ASA5520

Thanks Gilbert,

I found that I didn't need the trace command in the capture settings, and I used https://ipaddy/cap/capname and that did the trick.

Thanks again!

-Scott

144
Views
0
Helpful
3
Replies
CreatePlease login to create content