Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to configure routing on site to site VPN(RV215W)

Hi all

I have set up a VPN between a RV215W and SRP521 (site to site)

 

The VPN is up and connection is established on both side.

 

However I cannot connect from one network to another (No ping, no connection)

When I checked teh configuration, I noticed that route table on RV215W does not show any ipsec interface nor the route to the remote network

Any hint how to configure this route over the VPN? Should I do it manually or is it a paramater to be made automaticaly?

 

On the SRP215 the routing is as follow

Destination LAN IP 
Subnet Mask 
Gateway 
Interface
192.168.100.0255.255.255.0--VLAN100
192.168.15.0255.255.255.0--VLAN1
192.168.25.0255.255.255.0141.48.36.1ipsec0
41.0.0.0255.0.0.0--WAN1
41.0.0.0255.0.0.0--ipsec0
0.0.0.00.0.0.0141.48.36.1WAN1
    

 

On the  SRP only local and WAN are displayed

203
Views
0
Helpful
0
Replies