Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

how to configure VPN on SA520-k9

Hello for all. I'm trying to configure a VPN remote access type on a SA520-k9 but i don't know  why doesn't work.

My Internal network is 192.168.131.0/24 and my Wan Ip is 87.216.xxx.xxx.

on Remote WAN's IP Address / FQDN i put the WAN IP 87.216.xxx.xxx

on Local WAN's IP Address / FQDN I put the cisco SA520 Ip. I think this is the problem.

I create a IPsec user.

I create a firewall rule from WAN interface to SA520 Ip with IPSEC-UDP-ENCAP service.

I don't know what is wrong.

Can anyone help me?

Best Regards,

Ruben Ruiz

3 REPLIES
New Member

how to configure VPN on SA520-k9

Hello. i fix my problem, but now with the VPN ip i can't access to local network. I think i need to set a route from one network to the other, but i don't know where can i set this rule on SA520.

Thank you very much,

Best Regards,

Ruben Ruiz

New Member

how to configure VPN on SA520-k9

I am having the same issue. Does anyone have any suggestions?

New Member

how to configure VPN on SA520-k9

Hello, i solved the problem with the chat cisco support. Now, i use Cisco VPN Client.

follow this step.

1.- On Dinamyc IP Range, set tunnel mode to "Split tunnel" and set a range ip different of your network. Set dns servers.

2.- On VPN wizard, check Enable Cisco VPN Client, only set connection name a pre-shared key, then click ok.

3.- crete ipsec users

4.- Use vpn client to connect.

1543
Views
0
Helpful
3
Replies
CreatePlease to create content