How to install .xml profiles for Anyconnect for Mac??
I have AnyConnect 3.0.4235 installed on my Mac (OS X Mountain Lion), and my company uses .xml profile files so that the list of sites to connect to is autopopulated when you run the client.
I know where they go on Windows boxes, but have never done this on a Mac and have no idea where these .xml files should go. I tried putting them in the following location: opt/cisco/anyconnect/profile but when I run AnyConnect the "Connect to" box is still blank.
Does anybody know where these should go? Is there something else I need to do that I'm missing?
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...