Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to see Lan after VPN tunnel is established

After configuration VPN using L2TP on router users can connect to it.

But they can't connect to computers which are in the LAN after establishing the VPN tunnel.

How to do that?

4 REPLIES
Silver

Re: How to see Lan after VPN tunnel is established

Patryk,

When you mean "see Lan" are you saying that you can't browse your network or getting the NetBIOS messages.  When you vpn the router puts a /32 entry in its table out the WAN interface.  As a result if you are broadcasting stuff on your LAN and even if your vpn address is within that subnet, you won't see any of those broadcast packets.  You should be able to ping (unicast) those computers though.

-Jay

New Member

Re: How to see Lan after VPN tunnel is established

To 'see' I mean to can't ping server which is inside.

I can't ping from the contecet client to internal server even when the connection is established.

Silver

Re: How to see Lan after VPN tunnel is established

Patryk,

Without more detailed information about the issue there is not much to say, but here a few things to check:

1)  The subnet mask on the ip address pool.  This could be configured wrong.

2)  In the L2TP config on the client do you have the "use this as a default gateway" box checked

3)  When you do a ping to the internal client do you see decapsulations in the output of "show crypto ipsec sa"

4)  Are you able to ping the router's inside interface?

New Member

Re: How to see Lan after VPN tunnel is established

Thank you for support.

The problem was routing between 2 routers in LAN.

After configuration static routing now I can ping server.

Anyway thank's for sugestions.

335
Views
0
Helpful
4
Replies
CreatePlease login to create content