Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to show "ip local pool" information?

I'm doing simulation in Packet Tracer 5.2. I need to setup ezvpn on router 2811.

There's a command configuring a local ip pool like this:

#ip local pool mypool 192.168.1.100 192.168.1.110

My question is how to check out what local pools are there and what ip is in each pool ?

Is there any command like "sh ip int br" other than "sh run"?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: How to show "ip local pool" information?

The issue is with the simulator - it's got just enough functionality to perform basic tasks.

The command is available in full router IOS.

HTH>

5 REPLIES

Re: How to show "ip local pool" information?

show ip local pool

HTH>

New Member

Re: How to show "ip local pool" information?

Thanks. But the command is invalid in my simulator.

Is this the problem of Packet Tracer 5.2?

Or, is this command available on real 2811 router..?

Thanks, again.

Re: How to show "ip local pool" information?

The issue is with the simulator - it's got just enough functionality to perform basic tasks.

The command is available in full router IOS.

HTH>

New Member

Re: How to show "ip local pool" information?

Oh, I see. You're so quick. Thanks.

Re: How to show "ip local pool" information?

my lunch time!

NP.

4026
Views
0
Helpful
5
Replies