We are able to add individual objects (10.172.10.11/32) or subnets (10.172.10.0/27), but not a range of IP addresses (example: 10.172.10.11 to 10.172.10.99) as a part of subnet ? like we were able to do with Cisco VMS.
Is it any way that we can add only specific range of IP addresses (it need to be new network object) using ASDM or CLI?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...