Ah OK, my mistake. I was thinking ASA - I believe you are using an IOS-based VPN.
The state after establishment should be "QM Idle" (quick mode) - whether the Phase 1 was MM or AM.
I think you'll only see the AM in the debugs (like you have) or if you watch the output of the "show cry isa sa" command during establishment of the Phase 1 SA. If you're quick, you may see it cycle through as shown in this reference:
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...