access-list 115 permit ip 192.xx.xx.128 0.0.0.3 172.xx.1.0 0.0.0.3
(This configuration is incomplete / NAT configuration needed)
Here is the solution I am looking for:
When a session is initiated from the âInternal Networkâ to the âIPSEC Remote - 172.xx.1.0/30â network I want the â10.15.0.0/16â address scheme to translate to the NAT addresses â192.xx.xx.128/30â before routing over the IPSEC VPN Tunnel.
Please see "ATTACHED DIAGRAM" for more information.
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...