cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
479
Views
0
Helpful
2
Replies

Iphone and ASA

rdlucas
Level 1
Level 1

I am running ASA 8.0.3 and trying to get my iphone to connect in via IPSEC. It appears that my iphone gets an IP address from the ASA but after about 30 seconds it stops trying to connect and the error that I see in the ASDM is related to a phase2 issue. Any thoughts on what might be happening here?

713201 Group = TEST-VPN, Username = me, IP = 24.114.233.xxx, Duplicate Phase 2 packet detected. Retransmitting last packet.

2 Replies 2

ajagadee
Cisco Employee
Cisco Employee

Hi,

What type of encryption have you configured? Make sure that you have IPSec phase 2-3DES or AES encryption with MD5 or SHA hash method.

For example:

crypto ipsec transform-set trans esp-3des esp-sha-hmac

Regards,

Arul

*Pls rate if it helps*

Here is part of the config...

sh run | include crypto ipsec

crypto ipsec transform-set low-security esp-aes esp-sha-hmac

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: