Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

IPS 6.1, Inline VLAN Pairs

Hi.

Haven't touched a IPS in a while... Trying to configure VLANs 200 and 201 with IPS doing inline VLAN pair inspection. Configured switchport to gig0/0 on IPS as a trunk

switchport mode trunk

switchport trunk encap dot1q

Switch is 3524XL.

Configured a VLAN pair on IPS and assigned them to virtual sensor, but they will not pass traffic. When I use inline interface pairs instead, works fine. Any ideas???

BTW, on the trunk port I do a "show int fa0/11 switchport" and do notice the port in "Self Loopback: Yes". Not sure if this is normal in this type of install.

182
Views
0
Helpful
0
Replies
CreatePlease to create content