Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

IPSec andd ASA5520

I've two of ASA5520, Could I enable firewall in active/active while configure ASA to loadbalance IPSec from outside?

1 REPLY
Bronze

Re: IPSec andd ASA5520

Some tips on load balancing on ASA:

With Active/Active failover, both units can pass network traffic. This lets you configure load balancing on your network. Active/Active failover is only available on units running in multiple context mode. To provide load balancing, use Active/Active failover. If you do not want to provide load balancing, use Active/Standby or Active/Active failover

The security appliance does not provide load balancing services. Load balancing must be handled by a router passing traffic to the security appliance.

For load balancing configurations, you should assign each failover group a different unit preference

For more information see the link below:

http://www.cisco.com/univercd/cc/td/doc/product/multisec/asa_sw/v_7_1/conf_gd/failover.htm

132
Views
0
Helpful
1
Replies
CreatePlease to create content