Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

IPSec from PIX (6.3.5) to netscreen

Hello

I have problem with ipsec tunnel from pix to netscreen.

Ipsec connection works only when i remove EasyVPN configuration.

If EasyVPN config is applied, the ipsec negotiation is stopiing on phase 2 with ISAKMP state: OAK_CONF_ADDR

best regards

Martin

2 REPLIES
Gold

Re: IPSec from PIX (6.3.5) to netscreen

Martin

Verify your config on both devices with the following document:

http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a00801c4445.shtml

Hope this helps

New Member

Re: IPSec from PIX (6.3.5) to netscreen

I have read this document before I posted the message. My config is similar, without pfs. I don't use pfs. This is requirement from netscreen administrator.

The problem is EasyVpn, without it tunnel works correctly.

Martin

123
Views
0
Helpful
2
Replies
CreatePlease to create content