Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IPSEC Hub with Spoke Behind NAT device

I would like to setup an IPSec VPN, i have a challenge on how to do it because the Spoke device is behind a NAT device and also it uses dynamic IP addresses

, dwaring111.jpg

can anyone point me to the right article that can help me to do this, or can help by the required commands on the HUb and Spoke Routers

thanks

Everyone's tags (4)
1 REPLY
Cisco Employee

IPSEC Hub with Spoke Behind NAT device

If it's dynamic IP on the spoke, you can only create dynamic-to-static VPN tunnel, and the VPN tunnel can only be initiated from the dynamic/spoke end.

Here is a sample config for your reference:

http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a00801dddbb.shtml

Hope that helps.

888
Views
0
Helpful
1
Replies
CreatePlease login to create content