Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IPSec LAN-LAN Tunnel b/w 3005 and CheckPoint

Hi,

We have IPSec LAN-LAN tunnel configured between a Cisco VPN3005 and Nokia CheckPoint. However ocassionally the below message is showing up in the logs

(x.x.x.x = IP Address of Nokia CheckPoint)

++++++++++++++++++++++++

17161 01/05/2004 08:46:12.440 SEV=3 AUTH/5 RPT=16 x.x.x.x

Authentication rejected: Reason = Simultaneous logins exceeded for user

handle = 730, server = (none), user = x.x.x.x, domain = <not specified>

+++++++++++++++++++++++

Why would this message come up for a LAN-LAN Tunnel ? There is No Login from this peer, it is Not a Remote Access Connection.

We started seeing this message, since we upgraded the Concentrator from 4.0.1.A to 4.0.4.A.

Is it possible that Upgrade corrputed some of the database ?

Should i re-configure the Tunnel again ?

Regards,

\\ Naman

1 REPLY
New Member

Re: IPSec LAN-LAN Tunnel b/w 3005 and CheckPoint

On the 3005, go into:

Configuration>User Management>Groups

and find the L2L tunnel you are having the issue with and click "Modify Group". Click the "General" tab and make sure "Simulanteous Logins" is >0.

HTH,

Mike

190
Views
0
Helpful
1
Replies
CreatePlease to create content