IPsec remote VPN with Cisco client 5.0.07

[sapinder83]

                   Hi,

I am setting up remote IPsec VPN using ASDM for ASA 5505.

can somebody guide me for FOLLOWING;

1. step 6 for ASDM IPsec wizard: pool name: which IP addresses I have to assign here.

my network has inside IP 192.168.0.1 and outside IP 162.212.232.174

2. for VPN client: what would be Host IP??

what would be group authentication user name and password??

Please advice or provide me any link that can help me for this set up??

I need help for both VPN client setup and ASDM wizard for IPsec wizard.

Thanks,

Sap

[mvsheik123 · Accepted solution]

Hello,

Pool is the IP address range for VPN cleints (when connect to your network). Use a subnet different from your internal networks. ex: 192.168.10.0 255.255.255.0

Host IP: Your ASA 5505 public ip: 162.212.232.174

Group information- That you configure on ASA5505 and same needs to configured on client.

Check the below link (Search on line and you find lot of documentation).

http://www.databasemart.com/HowTo/Cisco_VPN_Remote_Access_Setup_ASA5500.aspx

Thx

MS

[andduart · Accepted solution]

Hi,

This one is very useful

http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a0080702992.shtml

Please let us know how it worked

Regards,

[sapinder83]

mvsheik123 wrote:
Hello,
Pool is the IP address range for VPN cleints (when connect to your network). Use a subnet different from your internal networks. ex: 192.168.10.0 255.255.255.0
Host IP: Your ASA 5505 public ip: 162.212.232.174
Group information- That you configure on ASA5505 and same needs to configured on client.
Check the below link (Search on line and you find lot of documentation).
http://www.databasemart.com/HowTo/Cisco_VPN_Remote_Access_Setup_ASA5500.aspx
Thx
MS

Thanks MS,

Host IP for VPN client will be outside interface IP for ASA???

I am trying that but getting attached error message.

pls advise

thx,

Sap

[sapinder83]

Thanks everyone for your comments,

now ASDM showing inside interface (VLAN1) up IP 192.168.1.1 and Outside interface (VLAN2) down.

Both should be up for remote VPN to work???

1. Please advise how I can make outside interface up and which IP address I have to assign using ASDM??

2. how I can assign inside IP in the same subnet as my network, because right now it is using defaut IP as inside IP.

Thanks,

Sap

[mvsheik123 · Accepted solution]

Hi,

Outside interface (VLAN2) down --> No.. it has to be up. Normally, the service provider Hand off connects to E0/0 of the ASA and E0/0 will be in Vla2. If it is showing down, You cannot access Internet from your LAN or you cannot access VPN host from outside. Thats why you are getting the error message.

Thx

MS