Re: IPSec VPN site-to-site setup using PIX and ASA
Thanks everyone. It really help and now its working after i run thoses
commands on both the ASA and PIX firewall.
Now I want to run ACL on VPN tunnel. Suppose i want to create an ACL to allow only to port 80, says there is a webserver running on SITEA. SITEB should only access that service from VPN tunnel. How should i create this ACL?
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...