Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Ipsec vpn using crypto map model and NAT.

Is there any example to follow about a simple site to site and nat scenario ?

My scenario is as follows :

(192.168.222.0/24) [CISCO_asr1002](200.1.1.1)=========(INTERNET)=======(201.1.1.1)[REMOTE_ASA]

REMOTE ASA, is not managed by me , so now I need to focus only only on the asr1002.

It would be great if someone can point some example to follow.

Thx.

Leandro.

2 REPLIES
New Member

Ipsec vpn using crypto map model and NAT.

Dear Collin Clark , thankyou very much for your response.

The link you recommend is great but I can not use it since the other end point device (ASA) doesnot support VTI model so both should stick to crypto map model.

Also , I need to use NAT for a new ipsec connection on a interface where I already have another working session without NAT ... Im wondering if this is possible ....

Ok , so if you can help me on this again It would be great, thanks !!

Leo.

149
Views
0
Helpful
2
Replies