01-06-2014 12:19 PM - edited 02-21-2020 07:25 PM
Is there any example to follow about a simple site to site and nat scenario ?
My scenario is as follows :
(192.168.222.0/24) [CISCO_asr1002](200.1.1.1)=========(INTERNET)=======(201.1.1.1)[REMOTE_ASA]
REMOTE ASA, is not managed by me , so now I need to focus only only on the asr1002.
It would be great if someone can point some example to follow.
Thx.
Leandro.
01-06-2014 02:03 PM
01-08-2014 05:14 AM
Dear Collin Clark , thankyou very much for your response.
The link you recommend is great but I can not use it since the other end point device (ASA) doesnot support VTI model so both should stick to crypto map model.
Also , I need to use NAT for a new ipsec connection on a interface where I already have another working session without NAT ... Im wondering if this is possible ....
Ok , so if you can help me on this again It would be great, thanks !!
Leo.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: