ISDN backup for Concentrator-to-router VPN using Dialer Watch
I've configured a lan-to-lan connection from a 3000 series Concentrator to a remote Router using IPSEC over the Internet.
I'd like the remote router to obtain routing information from the Central Concentrator, so it can use Dialer Watch. Dialer Watch would look for a routing table entry received from the Concentrator, and if it disappears use the ISDN interface to connect to the central site.
I've looked on Cisco's website and only found data on how to get routing information transferred to internal routers i.e routers connected via the private interface. Can it be done to remote VPN Routers over the public interface ?
Re: ISDN backup for Concentrator-to-router VPN using Dialer Watc
Yes, you can get routes advertised out the vpn3k public/private interface via RIP/OSPF, but they are not going to get encrypted, hence not much use, and this scenario is not going to be possible.
As an alternate, what you can do is to use a router inside the vpn3k, and use gre to encap OSPF/EIGRP on it, this way you can run routing protocol over the tunnel, and watch for the route, if it disappears, you can kick in your bri line.
DocumentationCode download linksGoalRequirementLimitationsSupported ISR and UCS-E ModelSupported ISRG2 and UCS-E Blades:Supported ISR4K and UCS-E Blades:Step by Step ConfigurationConfigure one of the connectivity options to access the Cisco IMC from the n...
Firepower Threat Defense (NGFWv) on UCS E-series - Transparent Mode in HA
DocumentationCode download linksGoalRequirementLimitationsSupported ISR and UCS-E ModelSupported ISRG2 and UCS-E Blades:Supported ISR4K and UCS-E Blades:Step by Step ConfigurationCo...
I am currently unable to specify "crypto keyring" command when configuring VPN connection on my cisco 2901 router.
The following licenses have been activated on my router :