Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Issue in configuring the QOS on GRE/IPSEC Tunnel

Hi,

My issue:

On WAN we need to give priority some traffic (say RDP and

voice ) and other default traffic should not be prioritized

When I apply the service policy on the tunnel. I get the

below error.

PDM_CORP_MPLS_RTR01(config-if)#service-policy output

tunnel_115_COCHIN I/f

shape class CLASS_PROJ_BDCAST_COCHIN requested bandwidth

600 (kbps),

available only 100 (kbps) I/f shape class CLASS_COCHIN_RDP

requested

bandwidth 2600 (kbps), available only 100 (kbps) I/f shape

class

CLASS_PROJ_BDCAST_COCHIN requested bandwidth 600 (kbps),

available only 100

(kbps) PDM_CORP_MPLS_RTR01(config-if)#

interface Tunnel116

description << SILUGURI to PDM GRE/IPSEC TUNNEL >>

ip address 10.60.254.2 255.255.255.252

ip tcp adjust-mss 1350

keepalive 1 3

tunnel source 10.60.255.111

tunnel destination 10.60.255.116

tunnel mode ipsec ipv4

tunnel protection ipsec profile SILUGURI_PDM_VPN

service-policy output tunnel_116_SILUGURI

we are doing in Router 3825

1 REPLY

Re: Issue in configuring the QOS on GRE/IPSEC Tunnel

You cannot attach a CBWFQ policy direct to a tunnel interface, you need to shape first then prioritize.

HTH>

165
Views
0
Helpful
1
Replies