Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Issue initiating Tunnel from IPSEC tunnel from 1841 router to ASA

Hi,

I have configured a IPSEC site to site tunnel between Cisco 1841 Router and ASA 5510. (the configuration is the same as it is in the example in the cisco site except for the route-map utilisation).

I am experiencing a typical problem while initiating a tunnel from the lan behind Cisco 1841. Tunnel does not come up but when I initiate traffic from the lan behind ASA the tunnel comes up and normal traffic passes through.

Can anyone please help me resolve this issue.

Regards,

K.V.Krisshna

7 REPLIES

Re: Issue initiating Tunnel from IPSEC tunnel from 1841 router t

can post the router config

Community Member

Re: Issue initiating Tunnel from IPSEC tunnel from 1841 router t

Hi Marwan,

Please find the config of the router attached.

Regards,

K.V.Krisshna

Silver

Re: Issue initiating Tunnel from IPSEC tunnel from 1841 router t

Hi,

If you use Route map , does it resolve your issue?

Re: Issue initiating Tunnel from IPSEC tunnel from 1841 router t

Can you post debugs for Phase 1?

Regards

Farrukh

Community Member

Re: Issue initiating Tunnel from IPSEC tunnel from 1841 router t

Hi Saju,

Thank you for the reply.

I have tried using the Route-map even but it did not work out.

Regards,

K.V.Krisshna

Silver

Re: Issue initiating Tunnel from IPSEC tunnel from 1841 router t

Hello ,

Your config looks ok to me except that you are not using route-map , but you have checked it gives you same result.

Can you post config from ASA side?

Also you can refer follwoing link :

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00805e8c80.shtml

If your configs are ok then you can consider opening cisco tac case and check if the IOS is not hitting any bugs etc.

HTH

Saju

Community Member

Re: Issue initiating Tunnel from IPSEC tunnel from 1841 router t

Thank you Saju,

The config seems to be ok with the eample config above. I guess i need to open a tac case with Cisco for further on this.

Regards,

K.V.Krisshna

210
Views
0
Helpful
7
Replies
CreatePlease to create content