I just purchased the RV180W and I'm trying to configure VPN using QVPN. When I try to connect via QVPN from my PC into the network, it connects, then immediatly gets disconnected. In the logs of the router, I'm getting an error that says: "Could not find configuration for xxxxxx"
I also get some warnings "no phase1 found for xxxxx" xxxxx = userid
My issue is that QVPN immediately disconnects.
Where are some info:
Under firewall I have the "Block fragmented Packets" disabled. I found this requirement on a forum.
Remote Management is enabled. Again, found this requirement on a forum
Can someone help. I'm technical but not in networking. So I'm struggling through this learning as I go.
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...