Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

L2L VPN "freeze" traffic

I have the following L2L VPN scenario:

(192.168.200.X)--Router2801 --|Internet|-- ASA5510 (192.168.10.X, 192.168.20.X, 192.168.30.X,....)

At Router2801 side I'm able to access any network at the ASA5510 side and vice-versa, but sometimes it seems connection cannot goes through even tunnel state showing state MM_ACTIVE. So I go into Router2801 and issue a ping (telling the source interface) to any address in any network at the ASA5510 and everything is fine again.

For example:

Router2801#ping 192.168.30.1 source 192.168.200.1

!!!!!

After that traffic from 192.168.30.x to 192.168.200.x is OK. The same for all other networks.

As far as I could note, from ASA side there's nothing I can do when the traffic stops flowing. At Router2801 any kind of traffic can "initiate" the flow again.

Any thoughts will be appreciated

Thanks

3 REPLIES
New Member

Re: L2L VPN "freeze" traffic

Someone?

Thanks

New Member

Re: L2L VPN "freeze" traffic

Olá.

If a ping from the 2801 solves your problem, you can configure an "ip sla monitor" on the 2801 and continuously ping your ASA side.

Just a workaround, but maybe it helps.

New Member

Re: L2L VPN "freeze" traffic

Ola Celio

It's not exactly what I was expecting, but it works... for now.

Thanks

130
Views
3
Helpful
3
Replies