Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

L2L VPN with nat

HI All

I am quite inexperienced on this subject and would greatly appreciate guidance on this

I need to create a VPN tunnel between our site and a remote site. 

On our site, we are a 192.168.0.X network our external ip address is 12.53.150.100

The site we will need to connect to is 69.144.38.48

We need to have it go from host to host meaning 192.168.0.97 --> 69.144.38.50 and they want our ip to be translated to 10.9.250.1

Thanks in advance

Jason

Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: L2L VPN with nat

Are you familiar with setting up a regular L2L tunnel? in addition to that, you would just need to create a policy nat:

access-list 100 extended permit ip host 192.168.0.97 host 69.144.38.50

static (inside,outside) 10.9.250.1 access-list 100

When defining your crypto ACL, you would specify 10.9.250.1 as the source instead of 192.168.0.97.

Let me know if you need any more help.

4 REPLIES
New Member

Re: L2L VPN with nat

Are you familiar with setting up a regular L2L tunnel? in addition to that, you would just need to create a policy nat:

access-list 100 extended permit ip host 192.168.0.97 host 69.144.38.50

static (inside,outside) 10.9.250.1 access-list 100

When defining your crypto ACL, you would specify 10.9.250.1 as the source instead of 192.168.0.97.

Let me know if you need any more help.

New Member

Re: L2L VPN with nat

Hi,  Thanks for the quick reply

Sorry I not too savy with this device+

I have created the L2L tunnel before using the ASA 5505 VPN wizard.

can you explain that a little more

Thanks

Jason

New Member

Re: L2L VPN with nat

Is it a PIX or an ASA? did the remote side give you any of their config? phase 1, phase 2, etc.

New Member

Re: L2L VPN with nat

Thanks!  was able to get it going with your help

313
Views
0
Helpful
4
Replies
CreatePlease login to create content