Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Lan 2 Lan over MPLS and can't use remote Internet Connection

We are setting up a Lan 2 Lan VPN using MPLS. The eqipment is a IOS 12.2 router to PIX 7.0. The tunnel is up and everyone can access the systems on each others LANS.

The Internet connection is connected to the PIX. The users on the Router end cannot connect to the Internet.

However, when the router side tries to connect to the Internet, they traverse the tunnel. It never goes out to the Internet. Can't figure out why.

There is a NAT 0 statement and a global (outside) statement on the PIX. For the lcoal networks. Does the PIX decryt the traffic, and then PAT it to the Internet, then send the return traffic back to the originating IP address?

1 REPLY
Green

Re: Lan 2 Lan over MPLS and can't use remote Internet Connection

I "think" this is what you're looking for...it applied to l2l tunnels as well.

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00805734ae.shtml

94
Views
0
Helpful
1
Replies