Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Lan to Lan tunnel between Juniper SSG5 and Cisco 3005 concentrator

Does anyone have a configuration example?

or have you successfully established a tunnel between these two devices? or between SSG5 and Cisco ASA 5520?

2 REPLIES
Cisco Employee

Re: Lan to Lan tunnel between Juniper SSG5 and Cisco 3005 concen

Thomas,

Since, both the devices support the IPSEC RFC, you should be able to build the ipsec tunnel between them.

Below is a URL that has information on Configuring IPSec LAN-to-LAN tunnel between the Cisco Pix Firewall and a NetScreen Firewall. Eventhough, this is for a Pix, it should help you on the Netscreen side. Also, below is another URL between Pix and VPN3000. By comparing both the URLs you should be able to build a tunnel between the VPN3000 and Netscreen.

http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a00801c4445.shtml

LAN-to-LAN IPSec Tunnel Between the Cisco VPN 3000 Concentrator and PIX Firewall Configuration Example

http://www.cisco.com/en/US/products/hw/vpndevc/ps2284/products_configuration_example09186a00800949d2.shtml

Regards,

Arul

*Pls rate if it helps*

New Member

Re: Lan to Lan tunnel between Juniper SSG5 and Cisco 3005 concen

We figured it out. Local Network configuration was not matching SSG configuration. Thanks for your reply.

1954
Views
3
Helpful
2
Replies